Chemical Mortar - CM410VESF

Vinleyster Styrene Free Variant

Chemical Mortar

 

Description

The CM410VESF is a high performance, high strength, premium grade, solvent free, pure epoxy based chemical. Chemical injection anchoring system is usedfor heavy duty structural applications. The dual cartridge format comprises of a resin and hardening agent in separate external compartments which are mixed to the correct proportions in the delivery nozzle when triggered using the required manual dispenser. It's non shrink, non sag and extended cure time formula makes this resin the ideal choice for large diameter, deep and oversized drill holes with variable embedment depths and also suitable for underwater use and in submerged drill holes.


Base Material

Base Material Recommended for use in reinforced and non-reinforced concrete, rock and stone. It also provides a higher grade bond than standard epoxy acrylate resin in solid masonry, hollow brick-work and pre-cast (requires suitable sleeve) with minimal shrinkage.


Feature

• Non Flammable.
• Non hazardous environmentally friendly low odor.
• Extreme heat and high chemical resistance.
• High load values in concrete and masonry for medium to heavy duty applications.
• Imparts no expansion stresses on the base material.
• Suitable for close to edge and reduced anchor center fixing.
• Usable in damp and wet environment and submerged drill holes.
• Rapid cure
• Vibration resistant
• Corrosion resistant

 Variant 410ml co-axial 10.1 ratio cartridge,  Material Vinlester Styrene Free

Chemical Anchor Studs Installation

Installation
Chemical Anchor Studs Installation
Chemical Anchor Studs Installation









Dispenser DM 410 - Steel body and mechanism


Chemical Guns

Description
The professional dispenser DM410 for use with chemical mortar cartridges CM410EASF & CM410VESF

 Variant 410ml 10:1 ratio cartridge
 Material Steel body and mechanism
dm410
 


Chemical Anchor Accessories

Blow out pump BP

Accessories for drill hole cleaning
Blow out pump BP

Description

The hand operated blow out pump BP is for drill hole cleaning prior to anchor installation.

 Variant Hand Operated
 Material ABS
dp280


Important note
Performance based on clean holes - Hammer drilled - blown and then brushed with a still metal brush & blown


Cleaning Brush CB

Cleaning Brush CB

Description

Wire brush CB is for thorough cleaning and hole preparation

 Variant Hand Operated
 Material Steel Body and Head
Product code



Mixer Nozzle MN - Plastic

Mixer Nozzle

Description

Spare mixer nozzle for use with chemical mortar cartridges CM300PESF, CM300EASF, CM380EASF, CM350VESF, CM380VESF & CM400PE

 Variant CO-axial
 Material Plastic
product code




Designed by: MID  I  Hosted by : PBD  I  Promoted by : GID